 |
||||
 |
||||
FAQ1:
|
What is the definition of the output voltage of software and hardware? |
|||
A:
|
The definition of hardware in FAB and SR Series is 0.1. |
|||
FAQ2: |
How to update the functions of SR Series? |
|||
A: |
The SR Series program software provide the function of updating online which enable updating
SR system on Internet.
|
|||
FAQ3: |
Can remote module be used in the shielding cabinet? |
|||
A: |
Yes, you can choose SR remote accessory SR-ENAT lengthened antenna. |
|||
FAQ4: |
There may be some mistake in property pins after updating the software of SR, how to
deal with it?
|
|||
A: |
Delete the connections between the property pins, or delete SLCD block then add it again. |
|||
FAQ5: |
How to set the address if there are several expansion modules for SR PLC? |
|||
A: |
When there are several expansion modules, users must pay more attention when setting the addresses.(There is mark on one side of the body of the expansion module.) Each one of the expansion modules connected together must have different addresses. |
|||
FAQ6: |
When FAB is not used for a while and after power is turned on, the clock will display “80”.What shall we do next? |
|||
A: |
That is because of the loss of the initial time. It is only needed to re-set the time. |
|||
FAQ7: |
That is because of the loss of the initial time. It is only needed to re-set the time. |
|||
A: |
In 1.2 km is better. |
|||
FAQ8: |
Does the internal clock stop when the FAB is power-off. |
|||
A: |
When the temperature of the cabinet is 25℃, the clock can still run 100 hours after the FAB is power-off |
|||
FAQ9: |
Can the relay output type of PLC run only 100,000 times? |
|||
A: |
It depends on the switch current. If the switch current is less than 10A, the relay can run far more than 100.000 times. |
|||
 |
||||
